Helldivers 2 CQC-2 Saber DIY Kit

Complete your Helldivers 2 cosplay with this 3D-printed CQC-2 Saber DIY kit. This prop is intended for cosplayers and makers who want to assemble, finish, and paint the saber themselves.

The full CQC-2 Saber is printed in CosPLA or ABS. You will receive the parts unfinished, giving you complete control over assembly, colors, weathering, and the final finish.

What's included?

You will receive an unfinished 3D-printed DIY kit consisting of:

• CosPLA parts for the complete CQC-2 Saber

• Separate parts that you assemble and finish yourself

What do you need to do yourself?

To achieve the final result, you still need to:

• Sand and remove any print lines

• Remove support marks and smooth the surface

• Glue and assemble the different parts

• Fill seams and imperfections

• Prime and paint

• Weather and further personalize as desired

Not included

The following materials and accessories are not included:

• Glue

• Putty or seam filler

• Sanding materials

• Primer and paint

• Sheath, holder, or attachment system

• Other finishing materials

Important to know

This product is supplied as an unfinished DIY kit and is not a ready-made cosplay prop. Small print lines, support marks, and other characteristics of the 3D printing process may be visible. These can be removed during sanding and finishing.

The CQC-2 Saber is intended solely as a cosplay accessory and decorative product. The prop does not have a sharp cutting edge, but due to its hard edges and protruding parts, it can still cause damage or injury if used improperly.

Therefore, do not use the saber to strike, stab, or fight. Always check the rules of an event or convention regarding cosplay weapons and props before bringing them.